Troubleshooting
PROBLEM | SOLUTION |
|
|
If the system does not arm. | • Check that the indicator on the Remote |
| turns on when you press ARM. |
| Replace the batteries and reregister the |
| Remote with the Console if necessary. |
Console displays PROBLEM followed by | One of the sensors/motion detectors has |
Zone number when you try to arm it. | not reported in, in the last 4 hours. |
| Check that the batteries in the sensor/ |
| motion detector are good. |
| Or a protected door or window is open. |
| If you need to arm the system and want to |
| ignore a sensor/motion detector which is |
| not functioning: |
| 1. Press CLEAR on the Console while the |
| problems is being displayed. |
| 2. Then press ARM on the Remote. The |
| problem zone is not protected but all |
| other zones are armed. |
40
Troubleshooting
PROBLEM | SOLUTION |
|
|
If you hear a repetitive trouble alarm when | Check the Console’s display. If a door or |
you try to arm the system, and it does not | window is open, its zone # will indicate |
arm. | there’s a PROBLEM. |
| • Press DISARM. Check each Door/ |
| Window Sensor is working properly and |
| that no doors or windows are open. |
| Then arm the system. |
| Or: |
| • While the trouble alarm is sounding, |
| press CLEAR on the Console to |
| bypass the problem zone (the display |
| shows that it has been BYPASSED). |
| Then arm the system again. |
| • Or if the display shows TAMPER, |
| check the cover on the Door/ Window |
| Sensor for that zone. |
| • Or check that the upper right lid on the |
| Console it closed. |
|
|
If the alarm trips when you enter the | Arm the system in the AWAY mode. |
house before you have time to disarm it. |
|
|
|
Lights will not turn on or off from the ON or | • Be sure you set the correct SECURITY |
OFF buttons on the Keychain Remote. | LIGHT Code in the Console, see pages |
| 26 and 35. |
| • Be sure the light you are trying to |
| control has its on/off switch in the on |
| position. Be sure its bulb is good. |
| • Plug the Module into another outlet |
| near the Console. |
| • Check that the indicator on the Remote |
| comes on when you press a button. |
| Replace batteries and reregister remote |
| if necessary. |
| • Check the dials on the Modules. |
|
|
41