X10 Wireless Technology SC1200 Changing your Personal Identification Number PIN, Installation

Installation

Changing your Personal Identification Number (PIN)

Press either of the Menu up/down buttons (under the lid to the bottom right of the display). The display then shows ENTER PIN (Personal Identification Number) in the top line.

ENTER PIN 12:00 am

The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom right of the display). This clears the top line and shows * for each number entered.

****

12:00 am

This takes you to the first level of the menu at step 1. This is the INSTALLATION level. The display looks like this:

1. INSTALL

Press an up or down menu button until you reach the NEW PIN menu, and then press OK (or press 5 to go directly to the screen below):

5. NEW PIN

Enter your new PIN (4 digits). Press OK.

Note, choose a PIN that you are not likely to forget (a birthday, for example). If you forget your PIN you will not be able use the system. If you do forget your PIN contact www.x10. com to find out how to reset your system.

Press Clear to back out of the menu. If you press Clear while entering numbers, before you’re finished setting the new PIN, it clears the numbers. If you press Clear after you’ve set the new PIN and pressed OK, you are asked to confirm, 1. YES, 2 NO. Pressing 1 takes you back to the HOME CONTROL screen. Pressing 2 stays in INSTALL mode.

24

Installation

Clearing the memory

Press either of the Menu up/down buttons (under the lid to the bottom right of the display). The display then shows ENTER PIN (Personal Identification Number) in the top line.

ENTER PIN 12:00 am

The default PIN is 0000, you’ll find out later (page 24) how you can change this, but for now press 0000 on the keypad (under the lid to the bottom right of the display). This clears the top line and shows * for each number entered.

****

12:00 am

This takes you to the first level of the menu at step 1. This is the INSTALLATION level. The display looks like this:

1. INSTALL

Press an up or down menu button until you reach the MEMORY CLEAR menu, and then press OK to go to the screen below (or press 6 to go into the MEMORY CLEAR menu ):

6.MEMORY CLEAR

Press an up or down Menu button to select the desired sub-menu.

CLEAR ALL SENSORS

CLEAR ALL REMOTES

CLEAR ALL TIMERS

MASTER RESET

Select the desired sub-menu item and then press OK. Press Clear to back out of the menu. You are asked to confirm, 1. YES, 2 NO. Pressing 1 takes you back to the HOME CONTROL screen. Pressing 2 stays in the MEMORY CLEAR menu. Note, selecting 4. MASTER RESET immediately takes you back to the HOME CONTROL screen.

25