Installation
Console setup Overview
Console keyboard buttons are as follows:
On Used to send an X10 On message or to enter am in a time. Off Used to send an X10 Off message or to enter pm in a time.
Menu up Used to initially enter the menu and then to move up through the items.
Menu down Used to initially enter the menu and then to move down through the items.
Clear Used to clear entries, back up through the menu levels, and to bypass problem Door/Window Sensors or Motion Detectors.
Enter Used to terminate an entry.
Arm Home Used to arm the console in the Home mode. Arm Away Used to arm the console in the Away mode.
Installation
Console setup Overview, cont.
After you’ve followed the steps on page 6 and 7 and connected power to the Console, the display shows the time of day at the left of the bottom line, with HOME CONTROL in the top line. See below:
HOME CONTROL 12:00 am
All features (except Home Control) require access to the Menu mode. To do this, press either of the Menu up/down buttons (under the lid to the bottom right of the display). The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN 12:00 am
The default PIN is 0000, you’ll find out later (page 24) how you can change this, but for now press 0000 on the keypad (under the lid to the bottom right of the display). This clears the top line and shows * for each number entered.
****
12:00 am
When you enter the PIN the display shows the First Level of the menu at step 1, below. See next page.
1. INSTALL
8 | 9 |
