Pioneer DRM-3000 Installation, Attach the base stabilizers, Lock the casters, Connect power cord

INSTALLATION

STEP 1

1. Attach the base stabilizers.

To prevent the unit from falling over, be sure to attach the accessory base stabilizers. The DRM-7000 is provided with four stabilizers (one at each corner), and the DRM3000 is provided with two (rear corners only).

Base stabilizer

NOTES:

¶Be sure to attach the base stabilizers before doing anything else.

¶Note that the base stabilizers also serve to protect the ports and cables on the rear of the unit.

¶Note that any damage incurred as a result of the unit falling over or any damage caused to the rear ports or cables as a result of a failure to install the base stabilizers will not be covered under warranty.

¶In the case of the DRM-3000, be sure to attach the stabilizers only to the rear corners of the unit.

2. Deciding on the location where the changer is to be installed

The changer is designed with a rear access door which can be opened in inserting or removing drives or disc magazines, and the location where the changer is to be installed should be chosen so as to allow a minimum of 50cm of space between the rear of the changer and the nearest wall so as to leave enough room to open the rear access door and insert or remove drives or disc magazines.

3. Lock the casters

Four casters at the bottom of DRM-7000/DRM-3000 allow it to be moved lightly but they must be locked soon if you place the changer on the chosen location. A caster is locked by lowering its lever.

Lock

4. Connect power cord

Insert the power cord into the power inlet on the rear of the changer and then insert the plug into a wall power outlet.

NOTE:

Always be sure to use only the power cord supplied with your changer.

Also be sure to follow the instructions on the label on the package and use only that cord designed for use in the location in which the power cord is to be used.

Minimum
50	cm
of

16

<DRC1184> En