REAR
1 | 2 |
|
Names and functions of individual parts
REAR ACCESS DOOR INSIDE
English
9
3
4
5
6
TERM | ID | POWER |
OFF | ON |
|
OFFON
C H A N G E R S C S I
A C I N
GND
7
8
1Rear plates
These plates cover the space for attaching the connector
panels.
2Rear access door
3Drive SCSI ports (attached connector panel)
4 SCSI ID switch (ID)
This switch is used to assign the changer SCSI ID. If you would like to decrement the displayed SCSI ID, push the small switch just above the numeric display by a nib. And if you would like to increment, push the small switch just below the numeric display. Note that SCSI ID is set to ‘6’ at the time of shipment.
5 SCSI termination switch (TERM)
This switch is for SCSI termination. Note that this switch is set ON at the time of shipment and it must be kept ON during the changer installation. But when the SCSI bus connection is completed and the changer is not the last device on the SCSI bus, it must be set OFF certainly.
6Changer SCSI ports (CHANGER SCSI)
7 Power switch (POWER)
This switch is used to turn the power to the changer on and off.
8 Power inlet (AC IN)
The power cord is inserted into this power inlet. (Note that you should always be sure to use only the power cord provided with your changer.)
9 Rear bays DRM-7000
For use with disc magazines: M8 – M15
For use with optional units/modules: Bays #1 – 16
For use with disc magazines: M4 – M7
For use with optional units/modules: Bays #1 – 8
15
<DRC1184> En