6. Closing access doors
First check to make sure that all components have been installed into place and all cables have been connected.
If this has been done, close the front and the rear access doors, then the initialization of the changer mechanism will begin.
When initialization has been completed, a message like that shown below will be displayed on the LCD message window.
The first line of this message is used to indicate the status of the disc changer mechanism, and the second line is used to indicate the installed drive number and to indicate whether or not a disc has been loaded into the drive in question.
Drive numbers are assigned in sequence from the lowermost to the uppermost drive.
NOTE:
If the maximum number of drives appears on the LCD message window is shorter than the number of drives installed, open the rear access door and check the power cables and the changer interface cables to all drives installed. (See System administrator mode: Door submodes on p. 37 for information on how to open the rear access door.)
Installation
English
23
<DRC1184> En
