Pioneer DRM-7000, DRM-3000 manual Release knob Label Lock release

Whenever a disc magazine is inserted into the changer, its ID will be automatically read in and displayed on the LCD message window within a few seconds.

A similar message will also be displayed whenever a disc magazine has been removed.

If both of these messages appear together in rapid succession, it indicates that a disc magazine has not been correctly inserted, and you should check the magazine to make sure that it has been inserted properly again.

2.Insert discs into a 20-disc hyper magazine and insert the magazine into the changer.

1 Turn the release knob to the vertical direction to unlock. 2 Insert discs.

3 Turn the release knob to the horizontal direction to lock the discs into place.

Release knob

Label

Lock release Lock

NOTES:

¶Insert with label facing upward.

¶Insert discs horizontally. Otherwise it may result in damage to the discs.

¶Be careful not to scratch the reflective signal recording surface.

¶Do not turn a disc magazine upside down while the lock is disengaged. Otherwise it may result in discs falling out of the magazine.

Installation

4Insert magazine into changer.

Once the hyper magazine has been inserted partly into the changer, it will be automatically loaded in.

English

ESC
F	ENT
UN
CTI
ON
LOCK
UNLOCK
PO
WER
ROB
B OTI
USYCS
DRIV
BUSE	MAIL
Y		SLOT
	OCC
		UPIED

When the hyper magazine has been loaded, a unique magazine ID will be displayed together with the record of the locking mechanism.

≠

Note that the magazine will be automatically ejected if the changer is unable to read the magazine ID, and that if this happens you should try inserting the magazine again.

NOTE:

If hyper magazine has been installed, see the instructions given in System administrator mode: Hyper submode (p. 35) removing the hyper magazine.

21

<DRC1184> En