This manual contains important instructions that should be followed dur-
ing installation and maintenance of the UPS and batteries.
Please read and follow all instructions carefully during installation
and operation of the unit. Read this manual thoroughly before at-
tempting to unpack, install, or operate.
CAUTION! Risk of explosion if battery is replaced ay an incorrect type.
CAUTION! The UPS must be connected to an AC power outlet with fuse or
circuit breaker protection.
DO NOT plug the machine into an outlet that is not grounded. If you need to
de-energize this equipment, turn off and unplug the UPS.
CAUTION! DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT!
Panamax does not sell products for life support or medical applications. DO
NOT use in any circumstance that would affect operation or safety of any life
support equipment, with any medical applications, or patient care.
CAUTION! The battery can energize hazardous live parts inside even when
the AC input power is disconnected.
CAUTION! To prevent the risk of fire or electric shock install in a temperature
and humidity controlled indoor area, free of conductive contaminants. (Please
see specifications for acceptable temperature and humidity range).
2
Important Safety Instructions
CAUTION! To reduce the risk of electric shock, do not remove the cover. No
user serviceable parts inside.
CAUTION! To avoid electrical shock, turn off the unit and unplug it from the
AC power source before servicing the battery or installing a component.
CAUTION! DO NOT USE WITH OR NEAR AQUARIUMS!
To reduce the risk of fire, do not use with or near aquariums. Condensation
from the aquarium can come in contact with metal current contacts and
cause the machine to short out.
Note: AC Power management devices, such as a UPS, have certain limita-
tions with regard to reactive loads and wattage. The MX5102 has a handling
capacity of 600VA or approximately 600 watts. Excessive power consump-
tion beyond these specifications can affect battery life and performance.
For pluggable equipment, the socket shall be installed near the equipment
and shall be easily accessible.
CAUTION: To reduce the risk of fire, connect only to a circuit provided with
a 20 amperes maximum branch circuit overcurrent protection in accordance
with National Electric Code, ANSI / NFPA 70.
To avoid electrical shock, a screwdriver must be used to remove screws to
open battery cover before replacing battery. Must close battery compartment
using screwdriver to tighten screws.

NOTE TO CATV INSTALLERS

This reminder is provided to call attention to Article 820-40 of the
NEC. That article provides specific guidlines for proper grounding. It
specifies that the cable ground shall be connected to the grounding
system of the building and as close to the point of entry as practical.
FCC Notice
FCC Notice
This equipment has been tested and found to comply with the limits for
a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the
instruction.
CAUTION: A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It is essential that only the supplied power cord be
used. Use only shielded cables to connect I/O devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the
guarantee of this device could void the user’s authority to operate the
equipment.