Panasonic 103PF12U manual Secure any excess cables with bands as required, Monitor terminal, See

Connections



AUDIO OUT Terminals connection

AC cord connection (see page 13)

R L

AUDIO OUT

Stereophonic sound code

audio equipment

line-in

– AC cord fixing		Close	Unplug the AC cord
		Push until
		the hook clicks.
	1 Plug the AC cord into		Unplug the
		Open	AC cord
	the display unit.	2. Pull off.	pressing the
	Plug the AC cord until
Note:			two knobs.
	it clicks.
Make sure that the		1. Keep the	Note:
	2 Fix the AC cord with
AC cord is locked on both		knob pressed.	When disconnecting the AC
the left and right sides.	the clamper.		cord, be absolutely sure to
– Cable fixing bands			disconnect the AC cord plug
			at the socket outlet first.
Secure any excess cables with bands as required.

Note:

Two fixing bands are supplied with this unit. In case of securing cables at four positions, please purchase it separately.

Pass the attached cable fixing band through the clip as shown in the figure.

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:	To loosen:
	Push the catch

	Pull
1	2						Pull
	R AUDIO	L	PR/CR/R PB/CB/B	Y/G			AUDIO	R	L
	COMPONENT/RGB IN
SLOT1	SLOT2		SLOT3		PC	IN	SERIAL	AUDIO OUT

Optional Terminal	Dual HDMI Terminals	COMPONENT/RGB IN and	From EXTERNAL
Board Insert Slot	(equivalent of Dual	Audio IN Terminals (equivalent	monitor terminal
(covered)	HDMITerminal Board	of BNC Component Video	on Computer
	(TY-FB10HMD))	Terminal Board (TY-42TM6A))	(see page 10)
	(see page 12)	(see page 12)

Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

From SERIAL Terminal on Computer (see page 11)

From input on audio amplifier (see page 9)

9