Basic Operations
Turn on/off the camera
While pressing the lock release button, move the POWER switch to ON or OFF.
Turn on the camera:The mode lamp (CAMERA) lights red (camera mode), and the camera enters recording standby mode.
Turn off the camera:The mode lamp (CAMERA) goes out.
•Depending on the setting made for the POWER SAVE item of the OTHER FUNCTIONS screen in the settings menu, the following will apply if no designated operations* are performed for approximately five minutes in the recording standby modes of CAMERA mode and PHOTO mode (when an SD Memory Card has been inserted while using the battery).
ON: The camera recorder turns off automatically.
OFF: Does not switch OFF the camera.
*See the setup menus, POWER SAVE (Page 111 of Vol.2) for details.
POWER
ON
OFF
Lock release button
Mode lamp
CAMERA
PB
PHOTO IN
AVCHD DV
POWER switch
Set the POWER switch to the ON position while pressing the lock release button.
The CAMERA lamp lights (red), and the camera enters recording standby mode.
Tally lamp
You can set the tally lamp to light in the following |
| |
situations by setting the REC LAMP item |
| |
(Page 110 of Vol.2) in the OTHER FUNCTIONS |
| |
screen to OFF. |
| |
The tally lamp light can be switched to FRONT, |
| |
REAR or BOTH with the setting menu. For more |
| |
details, refer to the setting menu REC LAMP item |
| |
(Page 110 of Vol.2). |
| |
• Battery is low (flashes 4 times per second) | Tally lamp (FRONT) | |
• Available SD Memory Card capacity is low | ||
| ||
(flashes 4 times per second) |
| |
• Remaining battery capacity is low |
| |
(flashes once per second) |
| |
• Remaining memory of the SD Memory Card is |
| |
low (flashes once per second) |
| |
In addition, the location set for the REC LAMP |
| |
item will flash when receiving commands from the |
| |
remote control. |
|
Tally lamp (REAR)
| LINE | MIC | LINE | MIC | AUDIO |
|
|
|
|
| |
| AUDIO |
| CH 1 OUT | ||
ON |
| ON |
| ||
| IN |
|
| ||
OFF |
|
|
| OFF |
|
MIC+48V |
|
|
| MIC+48V |
|
| CH 1 |
| CH 2 | CH 2 |
|
30