Operations Basic

Basic shooting operations

Preparing for recording

1 Set the camera’s power switch to OFF. (Page 30)

• Check that the mode lamp is off.

2 Slide the card cover upwards to open.

AUTO

MANUAL

MENU

FUNC/EXEC

ENTER

PAGE/ADV

ACCESS lamp

·Flashes during SD Memory Card access (recognition, recording, playback, deletion, etc.). For details, see “SD Memory Card ACCESS lamp”.

3 Fully insert an SD Memory Card into the card slot.

Insert the card in the direction shown until it clicks into place.

AUTO

MANUAL

MENU

FUNC/EXEC

ENTER

PAGE/ADV

4 Close the SD Memory Card cover.

• Ensure that the cover firmly clicks into place.

Do not perform any of the following operations while the SD Memory Card ACCESS lamp is flashing.

Performing these operations may damage the SD Memory Card or its contents, or cause the camera to fail to operate correctly.

Opening the card door and removing the SD Memory Card

Switching off the power

Removing the battery

Connecting or disconnecting the USB connection cable

Shaking or striking the camera

Always format SD Memory Cards that have been used in other devices when first using them with this camera. (Pages 28, 76 of Vol.2)

If “CHECK CARD” is displayed on the viewfinder, please remove the SD Memory Card and insert it again.

SD Memory Card ACCESS lamp

This lamp lights or flashes during memory card access.

Lit: Card inserted, read/write possible

Flashing (fast): Recognizing

Flashing (slow): Accessing (during recording/ playback/reading)

Off: Card not inserted, unformatted card inserted, write protected card inserted

AUTO

MANUAL

MENU

FUNC/EXEC

ENTER

PAGE/ADV

SD Memory Card access lamp

36