USER menu
<AUDIO>
(continued)
Item
Setting
No.
Superimposed
No.
Superimposed
display
716
REC CUE 0000
0001
0002
Description
display
CH1
This selects the input signal recorded in CUE.
CH2
0: The signal selected by SETUP-MENU No.714 is recorded
CH1+2
on CH1.
1:
The signal selected by SETUP-MENU No.715 is recorded
on CH2.
2: The signal selected by SETUP-MENU No.714 and
No.715 are mixed and recorded on CH1 and CH2.
718 DV
OUTPUT
0000
0001
0002
ST1
This selects the AUDIO CH1 and CH2 output signals during
ST2
DV format playback.
ST1+2
0: The CH1 track signals are output to CH1 and the CH2
track signals to CH2. (Only the sound during shooting is
output.)
1: The CH3 track signals are output to CH1 and the CH4
track signals to CH2. (Only the audio dubbing sound is
output.)
2:
The mixed CH1 and CH3 track signals are output to CH1
and the mixed CH2 and CH4 track signals to CH2. (The
sound during shooting and audio dubbing sound are
output simultaneously.)
<Note> This item setting is valid only when the tape recorded on the four channels of the DV format is
played back.
719
PB FADE
0000
0001
0002
AUTO This selects the processing method for the audio edit points
CUT
(IN point, OUT point) during playback.
FADE
0: According to the status during recording. (Setup menus
No.309, 310)
1: Forced CUT
2: Forced FADE
720
EMBEDDED 0000
AUD
0001
OFF
This selects whether to superimpose the audio data onto the
ON
serial output.
0: Data is not superimposed.
1: Data is superimposed.
<Note> This item is valid when the optional serial interface board has been installed.
721
LINE CH
0000
SEL
0001
PCM
This selects the audio output (LINE OUT).
AUTO
0:
PCM AUDIO or QUICK PCM AUDIO is output.
1: Whatever is selected by SETUP-MENU No.713 (MONI
CH SEL) output.
<Note> The PCM AUDIO or QUICK PCM AUDIO output is not affected by the AUDIO MONITOR
SELECT SW, and CH1 and CH2 are output independently.
722 INT SG
0000
OFF
This selects whether the internal signal is to be used for the
0001

ON

audio input signal.
0:
The internal signal is not selected.
1: The internal signal is selected.
<Note> The internal signal has a frequency of 1 kHz.
723 DV PB ATT 0000 OFF
This selects the audio output level for DV format playback.
0001
ON
0: The audio output level is attenuated (reduced).
1: The audio output level is not attenuated.
<Notes> As indicated below, whether the setting takes effect or not depends on the size of the cassette
tape used.
1. When an “L” size cassette is used
The setting takes effect only when “DV” has been selected as the setting for setup menu
No. 108 (FORMAT SEL).
2. When an “M” size cassette is used
The setting does not take effect.
3. When an “S” size cassette is used
The setting takes effect.
The underline on the setting item denotes the initial setting.
–37–