Error messages

Warning

Error No.
TV monitor display* Descriptions
VTR operation
E-00*
(Err-00)
SERVO NOT LOCKED
Error No. lights when servo disturbances continue for 3 or
more seconds during playback, recording or editing. Continued
E-01*
(Err-01)
LOW RF
Error No. lights when envelope levels approx. 1/3 that of
normal levels are detected for more than 1 sec. during
playback, recording or editing.
Error No. lights when a fan motor stops operating.
Stop
E-10*
(Err-10)
FAN STOP Stop
* Displays when warning information is checked by pressing the DIAG button.

AUTO OFF mode

The following error number flashes on the counter display section.
Error No.
Descriptions VTR operation
When condensation is detected, the error no. display flashes, and the unit goes into
EJECT mode. The drum rotates after the cassette tape is ejected to remove
condensation.
When the condensation has been removed, the error no. display disappears and the
VTR may be used.
<Note>
E-20
E-29
E-31
E-35
E-36
E-37
E-51 The message display flashes when the take-up reel has been rotating idly for a fixed
period of time while the start/end processing operation during loading (half position) is
being performed.
E-52
E-53
E-55
1) The drum rotates as soon as condensation is detected when the unit is in EJECT
mode.
2) When condensation is detected while a cassette tape is inserted, drum rotation stops,
the cassette tape is ejected and the drum rotation begins again.
EJECT
The cassette does not move up even when 6 seconds have elapsed since the VTR was
transferred to the eject mode.
Stop
The unloading operation is not completed within
10
seconds.
Stop
There is no response from the servo microcomputer for 1 or more seconds.
Stop
Only the servo microcomputer was reset in an instantaneous power failure.
Stop
The servo microcomputer does not follow the instructions of the system control
microcomputer even when
10
seconds have elapsed. Stop
Stop
After the cassette has been inserted, the tape take-up reel has not wound up the tape
while the total tape amount is not detected and while the tape is traveling at or above
the normal tape speed in the forward or reverse direction.
Stop
After the total tape amount has been detected, the amount of tape wound up on the
take-up reel and the amount of tape supplied by the supply reel differ to an abnormal
extent while the tape is traveling. Stop
The tape has not been wound up during unloading. Stop
–47–