Panasonic AJ-SD93, AJ-SDd93 manual 41

Error messages (continued)

Priority	Monitor display	Description	Corrective action	VTR operation
		This appears when an envelope level
	E-01	approximately one-third of the normal level	Clean the video heads.	O p e r a t i o n
	(LOW RF)	has been detected for more than one		continues.
		second during playback or recording.
	E-02	This appears when the error rate has
		increased to the extent that correction or	Clean the video heads.	O p e r a t i o n
	(HIGH ERROR
Low		interpolation was applied to either the video		continues.
	RATE)	or audio playback signals.

Error messages

Monitor display	Description	Corrective action	VTR operation
	If condensation is detected, the error number flashes
	and the unit transfers to eject mode. The drum rotates
	after the cassette is ejected to eliminate the
	condensation.
E-20	Once the unit is released from condensation status,
	the error message display is cleared and the VTR is	Leave the power on and
DEW			EJECT
	able to be used.	wait.
	• If condensation is detected in the eject mode, the
	drum starts rotating as soon as it is detected.
	• If condensation is detected when the cassette has
	been inserted, the drum rotation is stopped, and
	after the tape is ejected, the drum starts rotating.
	The unit switches to eject mode and if the cassette
	fails to move up within 6 seconds, this error number
E-29	flashes on the display.	Set the POWER switch
	Note:
FRONT LOAD		to OFF and then to ON	STOP
	If the cassette does not move down inside the
MOTOR		again.
	machine even when 6 seconds have elapsed since
	the cassette was inserted, the VTR is transferred to
	the eject mode.
	If the unloading operation is not completed within 6
E-31	seconds, this error number flashes on the display.	Set the POWER switch
	Note:
LOADING		to OFF and then to ON	STOP
	When the loading operation is not completed within 6
MOTOR	seconds, the VTR is transferred to the eject	again.
	(unloading) mode.
E-35	If there is no response from the servo microcomputer	Set the POWER switch
SERVO CONTROL	for 1 second or more, this error number flashes on	to OFF and then to ON	STOP
ERROR	the display.	again.
E-37	If 10 seconds or more elapses and the servo	Set the POWER switch
SERVO COMM	microcomputer has not followed orders issued by the	to OFF and then to ON	STOP
	system control microcomputer, this error number
ERROR	flashes on the display.	again.
E-51	If the take-up reel rotates without engaging for a	Set the POWER switch
FRONT LOAD	specific period of time during the start or end	to OFF and then to ON	STOP
	processing operation while loading is underway (half
ERROR	position), this error number flashes on the display.	again.

– 41 –