Chapter 4 Adjustments and Settings for Recording (continued)

4-1-2 Adjusting the Black Balance

The black balance must be adjusted when:

zYou use your AJ-SPC700P the first time;

zYour AJ-SPC700P has not been used for some time;

zThe ambient temperature has changed substantially;

zThe gain switchover value has been changed; or

zS.GAIN (super gain) has been set with the USER MAIN/ USER1/USER2 button.

1Set the switches as illustrated below.

AUTO W/B BAL switch:

OUTPUT: CAM

Used to perform ABB.

 

2Tilt the AUTO W/B BAL switch so that it is positioned at [ABB], then release it.

The switch returns to the central position with the black balance automatically adjusted.

3During adjustment, the viewfinder displays the following message:

<Notes>

zEnsure that the lens connector is connected and the lens iris is CLOSE.

zDuring a black balance adjustment, light is automatically cut off.

zDuring a black balance adjustment, the gain switchover circuit is automatically switched.

The viewfinder screen may flicker and/or display noise; this is not a failure.

zIf you find the black shading annoying after performing an auto black balance adjustment, adjust the black shading. To do so, go to the menu option DETECTION, move the cursor (), then press the JOG dial button. The menu option DETECTION can be found in the <BLACK SHADING> screen, which is accessible from the MAINTENANCE page.

Note that pressing the ABB switch for longer than five seconds automatically performs an auto black balance adjustment, followed by an automatic black shading adjustment. (For more information, see the menu option SHD. ABB SW CTL in [8-5-5 SW MODE].)

zTo cancel the automatic black balance adjustment in process (the viewfinder displays “ABB ACTIVE”), flip the AUTO W/B BAL switch down to [ABB] again.

If automatic adjustment is cancelled, the value in effect before automatic adjustment will be used.

Retaining black balances

Each value in memory is retained even if the video camera- recorder is turned off.

<Note>

During adjustment, the lens iris automatically becomes

CLOSE.

4The adjustment will take effect in a few seconds and the following message will appear:

The adjusted value is automatically stored in the memory.

32