Panasonic AW-PB506AL manual SDI card, EDH ENABLE/DISABLE Factory setting Enable

Major operating controls and their functions

SDI card

EVF I/F connector [EVF I/F]

The EVF I/F cable 9 from the interface bracket is connected here.

SDI output 1, 2 connector [SDI OUT 1, 2]

SDI signals are output from here.

Setting switches

	SW NO	OFF	ON
1	EDH	ENABLE	DISABLE
2	SETTING	E350	E860
3	DATA CLIP	NORMAL	CLIP
4	NTSC/PAL	NTSC	PAL

1:EDH <ENABLE/DISABLE> (Factory setting: ENABLE)

An EDH flag is added to SDI output at the ENABLE setting.

2:Model selection <E350/E860> (Factory setting: E350)

When the AW-E350, AW-E650, AW-E655 or AW-E750 is used, set this switch at the E350.

When the AW-E860 is used, set this switch at the E860.

3:DATA CLIP <NORMAL/CLIP> (Factory setting: NORMAL)

At the NORMAL setting, signal input is output at the same level at which it was input.

At the CLIP setting, signal input at less than 0% is output at 0%, and signal input at more than 100% is clipped at 100%.

4:NTSC/PAL switching <NTSC/PAL> (Factory setting: NTSC)

Leave this switch at the factory setting.

- (E) -