Panasonic AW-SW350E manual Installing the Device Driver, 22 E 23 E, USB cable

■INSTALLING THE DEVICE DRIVER

This section describes how to install the device driver used with the USB image transfer programme for the AW-SW350. In the example of the procedure given below, Windows XP is used as the operating system.

1 Insert the CD-ROM supplied with the AW-SW350 in the CD-ROM drive of the host computer. (In this example, E: is the drive used.)

2 Set the AW-SW350's Power Switch to ON, check that the Power Indicator has lit, and connect one end of the A-B type USB cable to the USB port on the rear panel of the AW-SW350 and the other end to the USB port on the host computer. (Fig.1)

BBOUT	GLIN				PVW		PGM OUT			VIDEO
	/BBOUT				OUT	2	1	5	4	3	2	1
												IN	Windows PC
		TALLY & INCOM										AUTO
												75 Ω
5	4				3		2	1
												OUT
								PGM		Y / C IN
	DC 12V IN						EXT
					USB			Y / C
	SET UP						TAKE	OUT
	1	2	3	4
								5	4	3	2	1

GND

AW-SW350 Rear

USB cable

Fig.1 Connections

3 When the host computer recognizes the AW-SW350, as shown in Fig.2, the Found New Hardware Wizard automatically starts up.

Fig.2 Found New Hardware Wizard start screen

4 When the screen for specifying the driver loading directory appears as shown in Fig.3, specify the \DRIVER folder of the drive where the CD-ROM supplied with the AW-SW350 was inserted, and load the driver. (In this example, E: is the drive used.)

Fig.3 Driver specification screen

5 When the device driver has been loaded, a screen similar to the one shown in Fig.4 appears. This completes the installation of the device driver.

Fig.4 Driver loading completion screen

ENGLISH

22 (E) 23 (E)