Main Menu (continued)
g About WFM
You can display the wave form monitor using the “WFM” function.
The display changes each time you press one of the buttons, [FUNCTION1] to [FUNCTION5] (J page 22), assigned with the [WFM] function (To use the “WFM” function, you must assign it to one of the [FUNCTION1] to [FUNCTION5] buttons).
Press the FUNCTION button assigned with the WFM function once.
Normal window | WFM display |
Press the same button again.
|
|
|
|
|
|
|
WFM (Wave Form |
| Monitor) | The window is displayed in 16:9 aspect. | |||
| ||||||
Restrictions on WFM
Even if “WFM” has turned ON”, “WFM” is not displayed when using the “PIXEL TO PIXEL” function, “YPBPR/RGB” set in “INPUT SELECT” menu is
g About PIXEL TO PIXEL and PIXEL POS.
Using the “PIXEL TO PIXEL” function, you can confirm a picture with the actual pixel count (only when the input is an HD signal).
First, press one of the buttons, [FUNCTION1] to [FUNCTION5] (J page 22), assigned with the “PIXEL TO PIXEL” function to turn it “ON”. With the function on, press another one of the buttons, [FUNCTION1] to [FUNCTION5] (J page 22), assigned with “PIXEL POS.”. Each time the button assigned with “PIXEL POS.” is pressed, the signal display position switches. (To use the “PIXEL TO PIXEL” function, “PIXEL TO PIXEL” and “PIXEL POS.” must be assigned to any two of the buttons, [FUNCTION1] to [FUNCTION5].)
|
| The underlined values are factory preset setting values. | |
Sub menu | Settings | Explanation |
|
PIXEL TO PIXEL*1*2 | <OFF> | Used to set the input signal size as the display size. | |
| <ON> | Compatible formats | |
|
| 1080/60I/59I/50I/30P/29P/25P/24P/23P/24PSF/23PSF, | |
|
| 720/60P/59P/50P(SDI/YPBPR) | |
|
|
| |
PIXEL POS. | <CENTER> | Used to set the signal display position when PIXEL TO PIXEL | |
| <LEFT TOP> | is on.*3 |
|
| <RIGHT TOP> | <CENTER> | center |
| <RIGHT | <LT> | top left |
| BOTTOM> | <RT> | top right |
| <LEFT | <RB> | bottom right |
| BOTTOM> | <LB> | bottom left |
|
|
|
|
*1 When PIXEL TO PIXEL is on, the following menu settings become invalid: “ON” for “ANAMO” and “UNDER” for “SCAN” set in “VIDEO CONFIG” Various “HV DELAY” settings in “FUNCTION”
“MARKER display”
*2 When the input signal is “SDI1”, “SDI2” or “YPBPR”, the setting takes effect. However, 1080/60P and 1080/50P signals are excluded.
*3 When the input signal format is 720, only CENTER is displayed.
25
