Panasonic CQ-C500U warranty Remote Control Preparation, Clock Adjustment

Set your car’s ignition switch to the ACC or ON position.

Preparation

Cancellation of Demonstration

The demonstration message appears for initial use.

1

2 Press [PWR] (Power).

3 Hold down [VOL] (PUSH SEL: Select) for 2 sec. or more to open the menu.

4 Press [VOL] (PUSH SEL: Select) to

select the Demonstration setting.

(“DEMO” is displayed)

5 Turn [VOL] counterclockwise.

For using the remote control, press [0] ().

Notes:

•To return to the regular mode, press [DISP].

•Refer to the section on “Function Setting” ( page 23).

•When “NO DISC” is displayed, the Demonstration cannot be cancelled.

Remote Control Preparation

Preparation Before Initial Use		Warning
Pull the insulation film
		Keep batteries and insulation film out of reach of
out from the backside of
		infants. If an infant ingests a battery, please seek
remote control gently.
		immediate medical attention.
	Insulation film	Cautions
Battery Replacement		• Remove and dispose of an old battery immediately.
		• Do not disassemble, heat or short a battery. Do not
Remove the battery	Tough pointed object	throw a battery into a fire or water.
holder with the remote		• Follow local regulations when disposing of a
control unit placed on a		battery.
flat surface.		• Improper use of a battery may cause overheating,
 Stick your thumbnail		an explosion or ignition, resulting in injury or a fire.
into the groove, and
push the holder in		Notice
the direction of the
		This product contains a CR Coin Cell Lithium
arrow, and at the
		Battery which contains Perchlorate Material - special
same time.	Back side
		handling may apply.
 Pull it out in the
		See www.dtsc.ca.gov/hazardouswaste/perchlorate.
direction of the
arrow using a tough		Note: Battery Information:
pointed object.
 Put a battery in the case		Battery Type: Panasonic lithium battery (CR2025)
		(Included in the remote control)
with () side facing up.
		Battery Life: Approximately 6 months under normal use
 Put the case back.
		(at room temperature)

Clock Adjustment

The 12-hour system is used for the clock. 1 Press [PWR] (Power).

2 Press [DISP].

3 Hold down [DISP] for 2 sec. or more.

4 Adjust the hour and press [DISP].

[]: Forward

[]: Backward

5 Adjust the minute and press [DISP] to confirm the adjustment.

[]: Forward

[]: Backward

Notes:

•Adjust the clock when “ADJUST” appears on the display.

•Hold down [] or [] to change numbers rapidly.

•When “NO DISC” is displayed, the clock cannot be adjusted.

10CQ-C500U