Panasonic CQ-RX100U Preparation, Cancellation Demonstration, Battery Installation, Clock Setting

Preparation

First Time Power On

Set your car’s ignition switch	ACC		Press [SRC] (PWR: Power).
1 to the ACC or ON position.		2
	ON

Cancellation of Demonstration

\CQ-RX400U\ \CQ-RX200U\

The demonstration message appears for initial use.

1 Set your car’s ignition switch to the ACC or ON position.

\CQ-RX400U\

\CQ-RX200U\

2 Press [SRC] (PWR: Power).

3 Hold down [VOL] (PUSH SEL: Select) for

2 sec. or more to open the function menu.

4 Press [VOL] (PUSH SEL: Select) to select DEMO.

5 Turn [VOL] counterclockwise.

For using the remote control, press [0] ().

Notes:

•To return to the regular mode, press [DISP].

•Refer to the section on “Function Settings”.

•When “NO USB” (\CQ-RX400U\) or “NO DISC” is displayed, the Demonstration cannot be cancelled.

Battery Installation

Pull the insulation film out from	Note: Battery Information:
the backside of the remote control	Battery Type: Panasonic lithium battery (CR2025) (Included
gently.	in the remote control)
	Battery Life: Approximately 6 months under normal use (at
	room temperature)

Clock Setting

The 12-hour system is used for the clock.

1 Press [DISP].

(clock display)

2 Hold down [DISP] for more than

2 seconds.

Hour blinks

3 Adjust the hour.

Hour entered

[]: sets the hour ahead.

[]: sets the hour back.

5 Adjust the minute.

Minute entered

[]: sets the minute ahead.

[]: sets the minute back.

6 Press [DISP].

Completed

Notes:

•“ADJUST” is displayed before adjusting the clock.

•Hold down [] or [] to change numbers rapidly.

•When “NO DISC” is displayed, the clock cannot be adjusted.

4 Press [DISP].		Clock Display at Power Off
	Minute blinks	Press [DISP] to change the display.
			Display off
			Clock display (Default)

- 13 -