Panasonic DMC-FX33 Folder Composition, Conditions under which a different Folder number is used

Connecting to other equipment

•If you use “Windows 98/98SE/Me”, download “QuickTime 6.5.2 for Windows” from the following site, and install it. http://www.apple.com/support/downloads/ quicktime652forwindows.html

•This software is installed as standard on a “Macintosh OS”.

∫Folder Composition

Folders are displayed as shown in the following illustration.

≥Built-in memory

•The data for up to 999 pictures recorded by the camera can be included in 1 folder. If the number of pictures exceeds 999, another folder is created.

•To reset the file number or the folder number, select [NO.RESET] in the [SETUP] menu.

∫Conditions under which a different

folder number is used

In the following cases, the picture is not recorded in the same folder as the previously recorded picture. It is recorded

≥Card

DCIM

100_PANA

1

100_PANA P1000001.JPG

2 3

P1000002.JPG

P1000999.JPG 101_PANA

999_PANA

in a folder with a new number.

1When the folder just recorded to contains a picture file with the number

999 in it (example: P1000999.JPG).

2When the card just recorded to contains, for example, a folder with the number 100 [100_PANA] in it and that card is removed and replaced with a card that has a folder with the number 100 in it recorded by a camera from a different maker (100XXXXX, with XXXXX being the name of the maker)

and then a picture is recorded.

3 When recording after selecting

[NO.RESET] from the [SETUP] menu.

MISC

PRIVATE 1

MEMO0001.JPG

2 3

MEMO0002.JPG

1Folder number

2 File number
3 JPG:	Pictures
MOV:	Motion pictures
MISC:	DPOF print
	Favorite
	Category slide show
PRIVATE1:	Clipboard pictures
(Built in memory	(P66)
only)

92

(Pictures will be recorded to a new

folder with a number sequential to the

folder recorded to immediately before.

By using [NO.RESET] on a card that

does not contain folders or pictures,

such as one just formatted, the folder

number can be reset to 100.)

∫About the PTP connection

If the OS is “Windows XP”, “Windows Vista” or “Mac OS X”, you can connect in PTP mode if you set the camera to [ ] mode and then connect to your PC.

•Pictures can only be read on the camera. They cannot be written to a card or deleted.

•When there are 1000 or more pictures on a card, the pictures may not be imported.

•Do not use any other USB connection cables except the supplied one.

•Do not disconnect the USB connection cable while [ACCESS] is displayed.

VQT1J82