Panasonic DMC-G1K Using the AC Adaptor, Connect the AC cable Connect the DC cable a

Others

Using the AC Adaptor

You can use the camera without worrying about battery discharge when it is connected to a PC or a printer if you use the DC cable (DMW-DCC3; optional) to connect the camera to the battery charger/AC adaptor (supplied) and connect the AC cable.

•Check that the camera is turned off.

•Close the flash.

Connect the AC cable.

Connect the DC cable A.

• Pull open the DC cable cover 1 and then connect the DC cable to the camera body using the same steps as “Inserting/Removing the Battery” (P22). Pull the DC cable through the opening as shown in the illustration and then close the battery door.

•Be careful not to catch the DC cable when

closing the battery door.

• You cannot charge the battery if you connect the DC cable (DMW-DCC3; optional).

Note

•Be sure to use the supplied AC cable and the prescribed DC cable (DMW-DCC3; optional) when using the battery charger/AC adaptor (supplied) as an AC adaptor.

•The camera becomes warm during use. This is not a malfunction.

•Disconnect the charger/AC adaptor and DC cable when the camera is not in use.

•The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet.

132 VQT1U32