Panasonic DMP-BBT01 owner manual Indicator illumination, Indicator LEDs Description

Indicator illumination

Confirm the following items in correspondence to the status of the LED of the unit.

An error condition exists when the Status LED is red. Open the panel at the side of the main unit and check the status of the indicator LEDs. If the red LED does not turn off even when following operation is performed, contact your dealer.

	Indicator LEDs		Description
			The remote control and main unit are using different
			codes. Remote control code may be changed when the
			battery is changed. Reset the settings of the main unit
			and the remote control to the states at the time of
			purchase with following operation.
			1 Turn the unit off once, and then turn it on again.
			2 Touch and hold [<] on the main unit for more than 4
Red flashes for 6 times
			seconds while the HOME menu is displayed.
			3 Press and hold [OPTION] and [G] at the same time
			for more than 5 seconds.
			Remote control code for the main unit and the remote
			control will be set to “1”. Change the settings as
			necessary. (> 33, “Remote Control Code”)
The red or green light flashes slowly
			The unit is carrying out an internal process. This is not a
			malfunction. You cannot operate the unit while the light
			is flashing. Wait for a while.
Red lights up
		Lights up	The unit fails to operate properly. Touch and hold [Í/I]
			on the main unit for 3 seconds to switch the unit to
			standby, then switch back on.
		Flashes
Red lights up
		Lights up	The USB device is drawing too much power. Please
			disconnect or remove the USB device from the unit.
			The USB device may be incompatible.
		Flashes
Red lights up			The unit is hot.
		Lights up	If the maximum operating temperature is exceeded the
			unit automatically switches to standby.
			In this case turn the unit off for approximately 30
			minutes and make sure that there is adequate air flow
			around the unit.

34 VQT3W08