38 VQT3W08
Cannot switch audio.
¾When connecting an amplifier/receiver using
DIGITAL AUDIO OUT or HDMI AV OUT
terminal, you cannot switch the audio if
“Digital Audio Output” is set to “Bitstream”.
Set “Digital Audio Output” to “PCM”. (>29)
Cannot hear the desired audio type.
¾Check the connections and the “Digital Audio
Output” settings. (>12, 29)
¾To output audio from a device connected with
an HDMI cable, set “HDMI Audio Output” to
“On” in the Setup menu. (>29)
Disc cannot be played.
¾The disc is dirty. (>4)
Still pictures (JPEG) do not play back normally.
¾The images that were edited on the PC, such
as Progressive JPEG, etc., may not be played
back.
I can’t play back BD-Live.
¾The SD card is write-protected. (>6)
¾Confirm that this unit is connected to the
broadband Internet. (>13)
¾Confirm the “BD-Live Internet Access”
settin g s. (>32)
¾Confirm an SD card is inserted into the SD
card slot. (>17)
I can’t connect to the network.
¾Confirm the network connection and settings.
(>13, 14, 31)
¾Check the operating instructions for each
device and connect accordingly.
When using wireless LAN connection, video
from the DLNA C ertifie d m e dia s e r v er is not
played back or video frames are dropped
during playback.
¾Higher transfer rate router such as 802.11n
(2.4 GHz) wireless router may solve the
problem. If you use 802.11n (2.4 GHz)
wireless router, it is necessary to set the
encryption type to “AES”.
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in
connection interruptions or other problems.
¾On the “Wireless Settings” screen (>31), the
continuous lighting of at least 4 “Reception”
indicators is the target for a stable connection.
If 3 or fewer indicators are lit or the
connection is being interrupted, change the
position or angle of your wireless router and
see if the connection state improves. If there
is no improvement, connect to a wired
network and perform the “Easy Network
Setting” (>14) again.
Audio
Playback
Network
DMP-BBT01_VQT3W08 _eng.book 38 ページ ２０１２年４月６日 金曜日 午後３時０分