Messages
The following messages or service numbers may appear on the TV or unit’s display.
On the television
Cannot play.
¾You inserted an incompatible disc.
Cannot play on this unit.
¾You tried to play a
¾Confirm “SD” on the unit’s display is not displayed and
No disc inserted.
¾The disc may be upside down.
$This operation is not available.
¾Some operations are unsupported by the unit. For example;
–
IP address is not set.
¾The “IP Address” in “IP Address / DNS Settings” is
The wireless access point currently has a low network security setting. It is recommended to change to a higher setting.
¾Authentication type for the wireless LAN is set to “Open system”, or the encryption type is set to “No encryption”. It is recommended to encrypt for safety reasons. For details, refer to the instructions of the wireless router being used. Encryption is required when playing back video, etc., from DLNA compatible devices.
On the unit’s display
F99
¾The unit fails to operate properly. Press [Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on.
HDMI ONLY
¾Some
NET
¾While connecting to a network.
No PLAY
¾There is a viewing restriction on a
No READ
¾The media is dirty or badly scratched. The unit cannot play.
PLEASE WAIT
¾The unit is carrying out internal process. This is not a malfunction. You cannot operate the unit while “PLEASE WAIT” is displayed.
REMOVE
¾The USB device is drawing too much power. Remove the USB device.
SET
(“ ” stands for a number.)
¾The remote control and main unit are using different codes. Change the code on the remote control.
Press and hold [OPTION] and the following button at the same time for more than
5 seconds depending on the indication.
SET 1: the green button
SET 2: the blue button
SET 3: the yellow button
U59
¾The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears.
Select a position with good ventilation when installing the unit.
40 VQT3V87
