Panasonic DMR-E85H manual Television operation, Point the remote control at the television

Television operation

You can configure the remote control TV operation buttons to turn the television on/off, change the television input mode, select the television channel and change the television volume.

Point the remote control at the television

While pressing [Í TV], enter the code with the numbered buttons.

e.g., 01:	[0] ➡ [1]
Manufacturer and Code No.
	Brand	Code
Panasonic/National		01, 02, 03, 04
GOLDSTAR/LG		15, 16
HITACHI		08
JVC		07
MITSUBISHI		09, 10
NEC		13
PHILIPS		12
SAMSUNG		12, 17, 18
SANYO		14, 19
SHARP		11
SONY		05
TOSHIBA		06

Test by turning on the television and changing channels. Repeat the procedure until you find the code that allows correct operation. ≥If your television brand is not listed or if the code listed for your television does not allow control of your television, this remote

control is not compatible with your television.

When other Panasonic products respond to this remote control

If other Panasonic products are placed close together, change the remote control code on the main unit and the remote control (the two must match).

Under normal circumstances use the factory set code “DVD 1”.

1 While stopped

Press [FUNCTIONS].

2 Press [3, 4, 2, 1] to select “SETUP” and press [ENTER].

3 Press [3, 4] to select “Others” and press [1].

4 Press [3, 4] to select “Remote

Control” and press [ENTER].

5 Press [3, 4] to select the code (“DVD 1”, “DVD 2” or “DVD 3”) and press [ENTER].

SETUP	Remote Control
	Press “±” and “ENTER” together
Tuning	for more than 2 seconds on the remote
Others	control.
Disc

6 To change the code on the remote control

While pressing [ENTER], press and hold the numbered button ([1], [2] or [3]) for more than 2 seconds.

7 Press [ENTER].

∫When the following indicator appears on the unit’s display

The unit’s remote control code

Change the code on the remote control to match the main unit’s (➡step 6).

[Note]

Executing “Shipping Condition” in the SETUP menu returns the main unit code to “DVD 1”. Change the remote control code to 1 (➡step 6).

Getting started

RQT7462

11