Problem Solving

Troubleshooting

Check

Action

Unit Does Not Operate

Does the display light?

Does the Energy Saver key flash (or light) and the display is turned OFF?

(See page 32)

Does any of the U## codes and messages appear on the display?

(U1, U13, U16....etc.)

Does the Add Paper indicator and message appear on the display?

Does the message and J## Codes appear on the display? (J00, J01, J02,...etc.)

Does E#-## codes and messages appear on the display?

The machine would not accept the next job during operation, instructed job would not be accepted for a long time period or job would not be completed.

Check if the Power Switch (Main Power Switch on the Left Side of the machine) is turned ON and if the power cord is plugged into the AC outlet.

Press Energy Saver key on the control panel.

Perform actions in accordance with each message.

Add paper. (See page 14)

Remove the misfed paper. (See page 18) Be sure to set paper as adjusted with paper guides. (See page 42)

Turn the Power Switch on the Left Side of the machine to the OFF* and ON position. If the error code does not clear, call your Service provider.

Turn the Power Switch on the Left Side of the machine to the OFF* and ON position.

NOTE:

*If the Hard Disk Drive Unit (DA-HD19) is installed, see page 13.

Light Copies

Does the exposure indicator say "LIGHTER"?

Does the replacing Toner Cartridge and message appear on the display?

Press the Darker Key. (See page 25)

Replace the Toner Cartridge. (See page 16)

56

Page 56
Image 56
Panasonic DP-180 appendix Troubleshooting, Check Action, Unit Does Not Operate, Light Copies