About condensation
If the player is moved suddenly from a cold place into a warm room (in winter, for example) or if the tempera- ture in the room in which the player is installed rises suddenly due to a heater, etc., water droplets (conden- sation) may form inside (on operating parts and the lens). When condensation is present, the player will not operate properly and playback is not possible. Let the player stand at room temperature for 1 or 2 hours with the power turned on (the time depends on the extent of condensation). The water droplets will dissipate and playback will become possible. Condensation can also occur in the summer if the player is exposed to the direct wind from an
Cleaning the product
Unplug the power cord from the power outlet when cleaning the player.
Clean the player using a soft cloth. For tough dirt, apply some neutral detergent diluted in 5 to 6 parts water to a soft cloth, wring out thoroughly, wipe off the dirt, then wipe again with a soft, dry cloth.
Alcohol, thinner, benzene, insecticides, etc., could cause the print or paint to peel off. Also, leaving rub- ber or vinyl products in contact with the player for long periods of time could mar the cabinet.
When using
Caution for when the unit is installed in a rack with a glass door
Do not press OPEN/CLOSE on the remote control to open the disc tray while the glass door is closed. The door will hamper the movement of the disc tray, and the unit could be damaged.
Cleaning the lens
The player’s lens should not become dirty in normal use, but if for some reason it should malfunction due to dust or dirt, consult your nearest Pioneer authorized service center. Although lens cleaners for players are commercially available, we advise against using them since some may damage the lens.
About copyrights
This product incorporates copyright protection technol- ogy that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be autho- rized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless oth- erwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
24En
