Panasonic DVC20 Selecting the remote control mode, Concerning the button-type battery

DVC20_Eng.book 16 ページ ２００５年１０月３１日 月曜日 午前１０時３６分

Before using

ªSelecting the remote control mode

If 2 cameras are used simultaneously, set the mode for one pair of camera-recorder and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button- type battery is replaced, the setting will revert to the default [VCR1].)

1Setting on the camera:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2Setting on the remote control:

STILL ADV PAUSE STILL ADV VOL

2	1
	STOP

VAR

[VCR1]:

Press [D] and [∫] simultaneously. 1 [VCR2]:

Press [E] and [∫] simultaneously. 2

ªConcerning the button-type battery

≥When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency.

≥Keep the button-type battery out of the reach of children.

≥If the remote control mode of the camera and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the camera is turned on, “CHECK REMOTE MODE” (-32-) will appear and operation is impossible. Set the same remote control mode.

≥The remote control is intended for indoor operation. Outdoors or under strong light, the camera-recorder may not operate properly even within the usable ranges.

≥Within a 1 m (3 feet) range, you can operate the remote control from beside the remote control sensor (LCD monitor side) of the camera-recorder.

16