Panasonic DVD-LA95 Power supply, Insert the battery, Operation range, Using the AC adaptor

	Preparing the remote
Started	control
	Insert the battery
Getting
	(Lithium battery)

2

13

Face + upwards.

∫Replacing the button-type battery The battery normally lasts for about a year. Replace if the remote control fails to operate the unit when used within the operation range.

Note

Refer to “IMPORTANT SAFETY INSTRUCTIONS” on pages 6 and 7.

Operation range

Remote control

signal sensor

About 7 m
(23 feet) in
front of the
signal sensor	30 °	30 °

Note

≥Do not expose the remote control signal sensor to bright light.

≥Do not place obstacles between the remote control signal sensor and the remote control.

10 ≥Do not use another unit’s remote control at RQT6025 the same time.

Power supply

BEFORE USE

Remove the insulation sheet from between the built-in battery and unit.

Insulation sheet

P	DC IN 9V
U
L
L

Built-in battery

Leave the built-in battery attached when- ever you use the unit.

You can power the unit in one of four ways. ≥AC adaptor (see below)

≥Built-in battery (➡ page 11)

≥Optional car adaptor (➡ page 34) ≥Optional battery pack (➡ page 35)

Using the AC adaptor

	DC IN 9V
This unit	1	DC IN 9 V %
(Left side)

	Household
	AC outlet
2	(AC 120 V,
	60 Hz)
	3

Note

Refer to “IMPORTANT SAFETY INSTRUCTIONS” on page 6.

The unit is in the standby condition (the [Í] indicator lights) when the AC power supply cord is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet.

∫When the unit is not going to be used

for a long time

The unit consumes 0.9 W when in standby mode.

To conserve power, disconnect the AC power supply cord from the AC outlet.