Panasonic EP-MA10 manual After Completing The Massage, Cleaning And Maintenance

English

AFTER COMPLETING THE MASSAGE

Return the seat to the original position

1 Check that there is nothing in the vicinity of the backrest or the legrest.

2 Press the button twice.

• The backrest and legrest will automatically return to their original positions.

The backrest and the legrest can be returned with the reclining button. (See page 16.)

3 Place the control panel in its holder.

4 Return the pillow to its original position if it was flipped.

Disconnect the power

See Warning No. 2 on page 1, Caution No. 2 on page 2, and No. 10 on page 3.

1 Slide the power switch to the “off” position.

2 Turn the lock switch key to the “lock” position and remove it.

3 Unplug the power cord.

4 The lock switch key must be stored out of the reach of children.

CLEANING AND MAINTENANCE

See Danger No. 1 on page 1.

Leather covering on the pillow, the back cushion and the unit

•Wipe these areas with a soft, dry cloth.

(Do NOT use cloths containing any kind of chemical, etc.)

•If the synthetic leather is particularly dirty, soak a soft cloth in water or a 3–5 % solution of mild detergent, wring it out thoroughly and tap the surface with it. Next, rinse the cloth in water, wring it out thoroughly and then wipe any remaining detergent from the surface, wipe the surfaces with a soft dry cloth and allow them to dry naturally.

(Do NOT use a hair dryer to try to dry the surfaces more quickly.)

•Wearing of denim, colored, patterned or other clothing with a tendency to fade should be avoided during use, as it could lead to discoloration of the synthetic leather.

•Do not allow these areas to come in contact with plastic for extended periods of time as this may lead to discoloration.

•Please do NOT use thinners, benzine or alcohol.

Pipe and plastic areas

1.Wipe the unit with a cloth that has been soaked in a mild detergent and then thoroughly wrung out.

2.Next wipe the unit with a cloth that has been moistened with just water and thoroughly wrung out. *Make sure you thoroughly wring out the cloth first when cleaning the control panel.

3.Allow the unit to dry naturally.

• Please do NOT use thinners, benzine or alcohol.

Coated fabric

1.Wipe the seat fabric with a cloth that has been soaked in a mild detergent solution and then thoroughly wrung out.

2.Use a brush to apply a mild detergent to areas where the coated fabric has become particularly soiled. Be careful not to brush the fabric too much as this may damage it.

3.Next wipe the fabric with a cloth that has been moistened with just water and then thoroughly wrung out.

4.Allow the fabric to dry naturally.

• Please do NOT use thinners, benzine or alcohol.

23