English
3. Attaching the side covers (On both the right and left sides)
The method for attaching the covers is the same for both sides. | Right Side Cover | Left Side Cover | |
The diagram shows the right side where the control panel stand is | |||
|
| ||
attached. |
|
| |
|
|
|
1 Insert the bottom tabs on the cover | 2 Insert the top tabs into the notches on | ||
into the bottom notches on the |
| the armrest. | |
armrest. | Right side cover | Notches | |
Bottom tabs | |||
Notches
Removing the side cover
1 Insert a
Top tabs
2 
Push the cover until you hear it click.
2 Push the top tab of the cover down to lift the cover.
3 Perform the same procedures as
1 and 2 above for the other gap.
4 Pull the cover up diagonally.
•Performing this procedure with the allen key or a Phillips screwdriver could damage the unit.
•The cover can be removed with light force instead of forcing it.
1
2 
Mark
4.Connect the power cord to the unit
1Check for dirt and damage on appliance inlet of the power switch section and the connector of the power cord.
2Insert the connector into the appliance inlet.
3Be sure to push the connector in all the way.
Appliance inlet
Connector
Power cord
Power switch section
13
