Panasonic ES7017 Brush cleaning, Replacing shaving head components, Replacing the inner blades

oping, and maintain the cutting per- formance.

With the system outer foil in place, apply some hand soap onto the outer foil.

Turn the shaver on and pour some water over the outer foil.

After about 10-20 seconds, turn the shaver off.

Remove the foil frame and clean it with running water.

Wipe off any moisture from the shaver with a dry cloth and remove the protective cap to allow the sys- tem outer foil to dry completely.

lease buttons and lift the system outer foil upward to remove it. To in- sert the new system outer foil, press down until it snaps into place.

Replacing the inner blades

(see fig. 8)

Squeeze the foil frame release but- tons and lift the foil frame upward to remove it. Remove the inner blades, one at a time, by grasping them firmly at both ends and pulling straight away from the shaver. To insert the new inner blades, hold the blades, one at a time, at both ends and press downward until they snap into place.

Brush cleaning

Squeeze the system outer foil re- lease buttons and lift the system outer foils upward to remove them (see fig. 7). Remove the inner blades by grasping them firmly at both ends and pulling them straight away from the shaver (see fig. 8). Clean the outer foils, the shaver body and the trimmer with the long side of the brush. Clean the inner blades with the short side of the brush. Do not use the short brush to clean the outer foils (see fig. 9).

Replacing shaving head components

It is recommended that you replace the outer foil at least every year and the inner blades at least every two years to maintain your shaver’s cut- ting performance.

Replacing the system outer foil

(see fig. 7)

Squeeze the system outer foil re-

7

For environmental protec- tion and recycling of materials

This shaver contains Nickel-Metal Hydride battery(s).

Please make sure that the battery(s) are disposed of at an officially as- signed location, if there is one in your country.

How to remove the built-in rechargeable battery(s) before disposal of the shaver

(see fig. 10)

The battery(s) in this shaver is not intended to be replaced by consum- ers. However, the battery(s) may be replaced at an authorized service center.The procedure described be- low is intended only for removal of the rechargeable battery(s) for the purpose of proper disposal.

1.Remove the cap, outer foil frame and inner blades.

2.Remove the two screws (b) and

OS01G110_ES7017_EUR_en 7 1/28/02, 9:35 AM