Lamp Indications | Panasonic EY6903 specification

Battery charger (EY0110)

1. Plug the charger into the AC outlet.

Note:

Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety.

2.Insert the battery pack firmly into the charger.

Battry pack

To AC outlet

Battery charger

3.During charging, the charging lamp will be lit.

When charging is completed, an in- ternal electronic switch will automati- cally be triggered to prevent over- charging.

Charging will not start if the battery pack is warm (for example, immedi- ately after heavy-duty operation).

The orange standby lamp will be lit until the battery cools down. Charging will then begin automatically.

4.When charging is completed, the charging lamp will start flashing quickly in green color.

5.When in any of the conditions that battery pack is too cool, or the bat-

tery pack has not been used for a long time, the charging lamp is lit. In this case charging takes longer to fully charge the battery pack, than the standard charging time.

If a fully charged battery pack is inserted into the charger again, the charging lamp light up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed.

6.If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer.

Note:

When charging a cool battery pack (below 5°C (41°F)) in a warm place, leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature.Otherwise battery pack may not be fully charged.