- 117 -
Others
•If the camera is moved too slowly, the camera assumes that camera motion was stopped and ends
the still picture recording.
•If there is a lot of camera shake in the recording direction while moving the camera, recording ends.
>When recording in Panorama Shot Mode, try to trace a small half-circle parallel to the recording
direction, taking about 4seconds to complete the half-circle (approximate).
•Depending on the operating conditions, it may take time to take the next picture if you repeat
the recording of pictures.
•It may take time to save pictures taken in Burst Mode on the card. If you take pictures
continuously while saving, the maximum number of recordable pictures decreases. For
continuous shooting, use of a high speed memory card is recommended.
•The burst speed (pictures/second) may become slower depending on the recording
environment such as in dark places, if the ISO sensitivity is high, etc.
•The burst speed becomes slower halfway.
The exact timing of this depends on the type of card and the Picture Size.
•This phenomenon appears when you press the shutter button halfway to set the aperture value and
does not affect the recorded pictures.
•This phenomenon also appears when the brightness changes when the camera is zoomed or when
the camera is moved. This is because of operation of the automatic aperture of the camera, and it is
not a malfunction.
•The monitor may flicker for a few seconds after turning this unit on. This is an operation to correct
flicker caused by lighting su ch as fluorescent lights, LED lights etc. and is not a malfunction.
•Is [Monitor Luminance] active? (P42)
•Perform [Monitor Display]. (P42)
•This is not a malfunction. These pixels do not affect the recorded pictures.
•In dark places, noise may appear to maintain the brightness of the monitor.
This does not affect the pictures you are recording.
Recording by Panorama Shot Mode is ended before finishing.
The Burst speed is slow.
Monitor
The monitor becomes darker or brighter for a moment.
The monitor flickers indoors.
The monitor is too bright or dark.
Black, red, blue and green dots appear on the monitor.
Noise appears on the monitor.