Panasonic HD3700H Home menu displays, ∑ Display lamps, CH1 AES, CH1 SER, Cue Mix

HOME menu displays

∑Audio signal display area (Either 8 or 4 channels will be automatically displayed depending on the

format used.)

Use this to adjust the level of the input audio signals on the AUDIO IN menu. Alternatively, it is used to adjust the level of the audio playback output signals on the AUDIO OUT menu.

Press the L/R buttons to select the audio channel whose signals are to be output from the AUDIO MONITOR L/R connectors and HEADPHONES jack.

These display the type of input signals of each channel.

The F1 (CH-1) to F6 (DIGITAL) [or F1 (CH-1) to F13 (CH-8) for 8 channels] on the AUDIO IN PCM INPUT SELECT menu are se- lected using the F9 (CH-MIX) key on the AUDIO IN CUE INPUT SELECT menu.

[---- ANA:		Signals from the ANALOG INPUT connectors.
CH1	AES:	Signals from the DIGITAL AUDIO INPUT connectors.
T
CH1	SER:	Signals from the serial V/A input connectors.
{---- INT:		Signals from the internal signal generator.
[----LINE:		Signals from the CUE IN connector.
CUE MIX:		CH1 to CH8 signals selected by CUE MIX setting.

{----AUTO: This is always used for digital channel backup pur-

poses.

∑Display lamps

SYSTEM: This indicates the video system format which was set on the SETUP/SYSTEM menu.

1080_59i

525_59i

1080_23psf

1080_24psf

720_59p

1080_50i

TAPE: This indicates the format of the playback tape. “¢¢¢¢¢¢¢¢” appears in the EJECT mode.

If a section is unrecorded or if the format of a section cannot be identified, the lamp blinks while the display of the format identified up to the section concerned is retained.

1080_59i, 1080_60i

1035_59i, 1035_60i

525_59i

1080_23p, 1080_24p

720_59p, 720_60p

1080_50i

How to display the ≥AUDIO IN menu:			≥AUDIO IN PCM INPUT SELECT menu:
menus:					#
		AUDIO IN		AUDIO IN			F6
	≥AUDIO OUT menu:		≥AUDIO IN CUE INPUT SELECT menu:
						#
		AUDIO OUT		AUDIO OUT				F7

– 8 –