■2nd display unit Installation

Be sure to disconnect the power cable of the main block (POS Workstation) and confirm the power is “OFF” before the operation below.

1. How to mount the 2nd Display Unit

(1)Loosen the thumbscrew on the lower portion of the rear cover at the rear display side of the main block by hand, and remove the rear cover.

*The thumbscrew shall be loosened until the screw rotates without resistance.

(2)Prepare a 2nd display unit to be used. (The contents here explain the 950SD010 type.) Confirm the wiring that VGA Cable and Speaker Cable are put along case of inside wall as shown in the fig. (2).

(3)Connect the connector of the 2nd display with the connector of the main block as shown in fig. (3).

(4)Attach the rear cover on the main block as shown in fig. (4)-1. And also, route the 2nd display’s cable (950SD010has 2 cables) in the groove as shown in fig. (4)-2. Then, tighten the thumbscrew on the lower portion by hand to secure the cover.

(5)In case of 950SD010, connect VGA cable and speaker cable to predefined I/F on I/O panel.

(6)Stand-up correctly.

(1)-1

(1)-2

(2)

 

 

(3)-1

(3)-2

(4)-1

 

 

 

(4)-2

(5)

 

(6)

LINE OUT

 

 

 

 

10