■Storage Unit Installation
Be sure to disconnect the power cable of the main block (POS Workstation) and confirm the power is “OFF” before the operation below.
1. How to mount the storage unit
(1)Disconnect the 2 latches on the upper portion of the filter cover of the main unit by both hands, pull the cover toward you while pressing the cover downward at the same time, and remove the filter cover.
(2)Insert the storage unit into the prescribed inlet of the main unit slowly and connect the connector of the main unit with the connector of the storage unit.
(3)Tighten the 2 thumbscrews supplied with the main unit by hand to secure the storage unit.
(4)Hitch the lower portion of the filter cover to the main unit, and push the cover until the latches of both sides on the upper portion are connected to secure the cover.
(1)(2)
(3)(4)
2. How to replace the storage unit
(1)Place the main unit to make the display unit in parallel with the mounting table.
(2)Disconnect the 2 latches on the upper portion of the filter cover of the main unit by both hands, pull the cover toward you while pressing the cover downward at the same time, and remove the filter cover.
(3)Loosen the 2 thumbscrews securing the storage unit by hand, hold the band on the front side of the storage unit and pull the band toward you slowly.
(4)Prepare a new storage unit.
Note: Exercise care to avoid any impact to the storage unit(s).
7