Be sure to disconnect the power cable of the main block (POS Workstation) and confirm the power is “OFF” before the operation below.
1. How to install the display unit
(1)Open the screw cover of the main unit (POS Workstation).
(2)Hold the display unit with both hands and insert the connector section of the display unit into the connector inlet guide of the main unit slowly to connect the connector.
Note: When the connector section is connected, do not press the LCD surface of the display unit.
(Failure to observe this may result in damage to functions of the LCD or touch panel.)
(3)Tighten the 2 thumbscrews of the main unit by hand to secure the display unit.
*Be sure to use hand when tightening the thumbscrews. Hold wire between the tips of one’s first two fingers as shown in figure (3), and then tighten it.
*Make sure that no looseness is detected when trying to move the display unit.
(4)Close the screw cover of the main unit.
(1) | (2) | (3) |
(4)
2. How to replace the display unit
(1)Place the main unit to make the display unit at right angle to the mounting table.
(2)Open the screw cover of the main unit.
(3)Loosen the 2 thumbscrews securing the display unit.
*The thumbscrews shall be loosened until the screws rotate without resistance.
(4)Hold the both sides of the display unit and pull out the unit slowly.
(5)Prepare a new display unit and perform replacement in accordance with the procedure 1, “How to install the display unit”.
6