19.7. Transmitter/Receiver
Base Unit and Handset are mainly consists of RF(Radio Freque ncy) IC and CPU.
Base Unit and Handset transmit/receive voice signal and data signal through the antenna on carrier frequen cy.
Signal Pass :
*Refer to CDL TX/RX in Signal Route (P.46).

19.7.1. Base to Handset

Circuit Operation:
The voice signal input from the TEL LINE interface goes to RF IC as shown in
BLOCK DIAGRAM(BASE UNIT) (P.38).
In the talk mode (off-hook) condition, the telephone line voice signal passes through D2, D3, D4, D5, RY1 (Relay), R107 and
T7.
The other party´s voice signal is coupled with T7 and amplified by Q11 and led to IC3-B (OP Amplifier device).
And the signal goes through the compressor of RF IC, it is out put to transmitter circuit.
The signal of the data sent to the handset is applied in the anode of the variable capacitor diode ( VARICAP : DV1).
The capacitor of VARICAP is changing in accordance with the voice signal from telephone line interface or TX DATA signal from
CPU. Therefore, the carrier frequency which is generated by TXVCO will be changing, and Frequency modula ted RF
signal is generated and amplified by RF AMP(Q3, Q4, T5). It pass t hrough the Duplexer DPX1 and radiated from Antenna.
The signal is transmitted from the base unit and received by the handse t antenna and amplified by RF amplifier (Q1) through
DPX1 as shown in BLOCK DIAGRAM(HANDSET) (P.39). And then it is converted to 10.7 MHz and 455 KHz Intermediate
frequency by RF IC and related components.
The demodulated audio signal is output from RF IC (DET OUT) and passed through "Expander" process to reduce noise, then
voice signal amplified by "Receiver amplifie r" is output to receiver (REC1).
The receiver loudness is adjustable using "LOUD" key on the handset. Q2 and Q3 control the volume. When CPU (VO L1)
becomes low, the volume becomes "MID", while CPU (VOL1, 2) become low, the volume becomes "HIGH" .
TX data (to Handset)
CPU (VTX) becomes low to turn on the transmission power transist or Q2, and CPU (TX-data) sends data signal. It is
FM-modulated by TXVCO and driven by RF AMP, then transmitted to the handset.
44
KX-TC2000NZB / KX-TC2000NZW / KX- TC2000NZF