98
Answering System
Remote Operation from a Touch Tone Phone
You can operate the answering system from any touch tone phone.
Firstly you must store your remote code using the handset near the base unit.
The 3-digit remote code prevents unauthorized use of your answering system for
listening to recorded messages.
Setting the Remote Code ON
Setting the Remote Code OFF
•The factory preset is Remote Code OFF.
Turning ON the Answering System Remotely
You can turn on the answering system from any touch tone phone.
•If your remote code is not stored, you cannot turn on the answering system remotely.
1
Press JOYSTICK
(or move).
2
Select “ TAM
Operation”.
3
Select “Setting
TAM”.
4
Select “Remote
Code”.
5
Enter 3-digit Remote
Code.
6
Press JOYSTICK.
Follow steps 1 to 4 shown above, then:
5
Press `.
6
Press JOYSTICK.
1
Call from a touch tone phone
then wait for 15 rings.
2
Enter remote code within 10 seconds after a long
beep.
3
Re-enter remote code after
the greeting message
playback.
4
Voice menu starts after 3 seconds.
Follow the guidance (p. 100).
OR
Enter your desired direct remote command
(see next page).