Panasonic KX-TG1233BX, KX-TG1223BX operating instructions Ringer setup, Night mode

TG1223-1233BX(e-e).book Page 32 Wednesday, November 15, 2006 3:32 PM

Base Unit Settings

Ringer setup

Night mode

Night mode allows you to select a block of time during which the base unit will not ring for outside calls. This feature is useful for times when you do not want to be disturbed, for example, while sleeping. Night mode can be set independently for the handset (page 27) and the base unit.

Set the date and time beforehand (page 12).

Note:

L To avoid disturbances, we recommend turning the call screening feature off (page

45)in addition to turning the night mode feature on (KX-TG1233 only).

Setting the start and end time for night mode

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). L If you changed the PIN, enter it (page

35).

4Select “Ringer Setup”, then press

{>}.

5Select “Night Mode”, then press {>}.

6Select “Start/End”, then press {>}.

7Enter the desired hour and minute you wish to start this feature by selecting 2 digits for each.

L If you use 12-hour time entry, select “AM” or “PM” by pressing {*} repeatedly before entering the time.

8Enter the desired hour and minute you wish to end this feature by selecting 2 digits for each.

L If you use 12-hour time entry, select “AM” or “PM” by pressing {*} repeatedly before entering the time.

9Press {j/OK}.

10Press {ih}.

Turning night mode on/off

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). L If you changed the PIN, enter it (page

35).

4Select “Ringer Setup”, then press

{>}.

5Select “Night Mode”, then press {>}.

6Select “On/Off”, then press {>}.

7Select “On” or “Off”, then press {>}.

8Press {ih}.

Setting the ring delay for night mode

This setting allows the base unit to ring during night mode if the caller waits long enough. After the selected amount of time passes, the base unit will ring. If you select “No Ringing”, the base unit will not ring during night mode.

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). L If you changed the PIN, enter it (page

35).

4Select “Ringer Setup”, then press

{>}.

5Select “Night Mode”, then press {>}.

6Select “Ring Delay”, then press {>}.

7Select the desired setting, then press

{>}.

8Press {ih}.

Note:

L When the answering system answers the call, this feature does not work (KX- TG1233 only).

32