Panasonic KX-TG2314 manual Troubleshooting

Troubleshooting

If the handset display shows error messages, see “If the Following Appear on Your Display...” (p. 50 – 51) for the Cause & Remedy.

Problem Cause & Remedy

“No link to base. Move

closer to base, try again.” is displayed and an alarm tone sounds.

•You are too far from the base unit. Walk closer to the base unit.

•Confirm the base unit’s AC adaptor is plugged in.

•Raise the base unit antenna.

•If the above remedies do not solve the problem, the handset may have lost communication with the base unit. Register the handset again (p. 45).

The handset and/or base unit does not work.

•Check the settings (p. 8 –10).

•Check whether the dialing mode setting is correct (p. 13).

•Fully charge the battery (p. 9).

•Clean the charge contacts and charge again (p. 10).

•Check battery Installation (p. 9).

•Unplug the base unit’s AC adaptor to reset it. Plug in, and try again.

•Re-install the battery (p. 9) and fully charge it.

Static, sound cuts in/out,	• Move the handset and base unit away from
fades. Interference from other	other electrical appliances (p. 3).
electrical units.	• Walk closer to the base unit.
	• Raise the base unit antenna.
The handset does not ring.	• The ringer volume is turned off. Set to high,
	medium, or low (p. 15).
The handset display is blank.	• If the handset display is blank, fully charge
	the battery (p. 9).
You cannot program any	• Programming is not possible while the
function items.	handset and/or base unit is being used.
	• Do not pause for over 60 seconds while
	programming.
	• Walk closer to the base unit.

While programming or searching, the handset starts to ring and the program/ search stops.

•A call is coming in. To answer the call, press [C] or [s]. Start again from the beginning after hanging up.

52