Panasonic KX-TG2523E, KX-TG2524E, KX-TG2521E, KX-TG2522E Liquid damage Problem Cause/solution

TG251x_2xE(e).book Page 40 Monday, January 25, 2010 3:09 PM

Useful Information

Liquid damage

Problem	Cause/solution
Liquid or other form of moisture	L Disconnect the AC adaptor and telephone line
has entered the handset/base	cord from the base unit. Remove the batteries
unit.	from the handset and leave to dry for at least
	3 days. After the handset/base unit are
	completely dry, reconnect the AC adaptor and
	telephone line cord. Insert the batteries and
	charge fully before use. If the unit does not
	work properly, contact an authorised service
	centre.

Caution:

LTo avoid permanent damage, do not use a microwave oven to speed up the drying process.

Registering a handset to the base unit

1Handset:

{j/OK}

2{V}/{^}: “Handset Setup” i{j/OK}

3{V}/{^}: “Register H.set” i{j/OK}

4Base unit:

Press and hold {x} for about 5 seconds. (No registration tone)

L If all registered handsets start ringing, press the same button to stop. Then repeat this step. (KX-TG2512/KX-TG2513/KX-TG2522/KX-TG2523/ KX-TG2524)

L The next step must be completed within 90 seconds.

5Handset:

Wait until “Enter Base PIN” is displayed. iEnter the base unit PIN (default: “0000”). i{j/OK}

L If you forget your PIN, see page 37.

L When the handset has been registered successfully, w stops flashing.

Note:

L If the registration fails, try to deregister the handset and then re-register it again. Press {j/OK} i{V}/{^}: “Base Unit Setup” i{j/OK} i{3}{3}{5} i{j/OK} iSelect the handset(s) you want to cancel, by pressing the desired handset number. i{j/OK} i{V}/{^}: “Yes” i{j/OK} i Repeat from step 1.

40Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333