Useful Information
Error messages
Display message
Failed
Incomplete
Memory Full
No link to base. Reconnect AC adaptor.
Cause/solution
RPhonebook copy failed (page 16). Confirm the other handset (the receiver) is in standby mode and try again.
RThe receiver’s phonebook memory is full. Erase the unwanted phonebook entries from the other handset (the receiver) and try again.
RThe phonebook memory is full. Erase unwanted entries (page 16).
RThe handset has lost communication with the base unit. Move closer to the base unit and try again.
RUnplug the base unit’s AC adaptor to reset the unit. Reconnect the adaptor and try again.
RThe handset’s registration may have been cancelled.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the handset.
General use
Problem
The handset does not turn on even after installing charged batteries.
The unit does not work.
The handset display is blank.
Cause/solution
RPlace the handset on the base unit or charger to turn on the handset.
RMake sure the batteries are installed correctly (page 9).
RFully charge the batteries (page 9).
RCheck the connections (page 9).
RUnplug the base unit’s AC adaptor to reset the unit and turn off the handset. Reconnect the adaptor, turn on the handset and try again.
RThe handset has not been registered to the base unit. Register the handset (page 31).
RThe handset is not turned on. Turn the power on (page 12).
28
2012/09/19 15:02:01
