59
For assistance, please call: 1-800-211-PANA(7262)
Useful Information
Troubleshooting
If the display shows error messages, see “If the Following Appear on Your
Display...” (p. 56–58) for the Cause & Remedy.
Problem Cause & Remedy
The unit does not work. • Check the settings (p. 10–12).
• Check whether the dialing mode setting is
correct (p. 17).
• Charge the battery fully (p. 11).
• Clean the charge contacts and charge again
(p. 12).
• Install the battery properly (p. 11).
Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• The cordless handset has not been
registered to the base unit. Register the
cordless handset (p. 20, 55).
• Re-install the battery (p. 11) and charge it
fully.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
•Move the cordless handset and the base unit
away from other electrical appliances (p. 3).
•Walk closer to the base unit.
• Raise the base unit antennas.
• Press
[]
on the cordless handset to turn on
the Reception Booster feature (p. 24).
The base unit and/or cordless
handset does not ring.
• The ringer volume is OFF. Set to HIGH,
MEDIUM or LOW (p. 18).
• If more than one other unit is in use, the
cordless handset/base unit may not ring.
Users will hear incoming call tones (p. 49).
The display of the base unit or
cordless handset is blank.
• If only the cordless handset display is blank,
charge the battery fully (p. 11).
• If you are having a conversation using the
base unit handset during a power failure and
power returns to the base unit, the display will
be blank until you hang up the call. After
hanging up, the display will function.
While programming or
searching, the unit starts to
ring and stops the program/
search.
•A call is coming in. To answer the call, lift the
base unit handset, or press [DIGITAL
SP-PHONE], [] or []. Start again from
the beginning after hanging up.