Preparing the Answering System

22

To check the greeting

Press [GREETING].
The greeting will be played.

To erase the greeting

Press [GREETING], then press
[ERASE] while the recorded
message is being played.
The unit will answer calls with a
pre-recorded greeting.

Pre-recorded greeting

I
f you do not record a greeting (p. 21),
one of two greetings will be played when
a call is received, depending on the
callers recording time (see below).
To check the pre-recorded
greeting, press [GREETING].
A pre-recorded greeting will be played
as follows:
When the recording time is set to
1 minute, 2 minutes or 3 minutes:
Hello, we are not available now. Please
leave your name and phone number after
the beep. We will return your call.
When the recording time is set to
Greeting only: Hello, we are not
available now. Please call again. Thank
you for your call.
Flash Memory Message Backup
(Message storage)
Messages stored in memory will not
be affected by power failures. All
messages are saved until you erase
them.

Callers Recording Time

You can select 1 minute, 2 minutes, 3 minutes or Greeting only for the callers
recording time. The factory preset is 3 minutes.
1Press [FUNCTION/EDIT].
2Scroll to Initial setting by pressing
[] or [], then press [].
3Scroll to Set answering by pressing []
or [], then press [].
4Scroll to Recording time by pressing
[] or [], then press [].
5Select the recording time by pressing [] or
[].
You can also select the recording time by
pressing [1], [2], [3], or [0] (Greeting only).
6Press [] (Save), then press [STOP].
If you select Greeting only, the unit will answer a call with the greeting
message, and then hang up. The unit will not record any incoming messages.
Base Unit
Initial setting
Set answering
Recording time
Recording time
:3min