68
If the Following Appear on Your Display...
If the unit detects a problem, one of the following messages will be displayed on the
handset or the base unit. Error beeps or a busy tone will sound.
Display message Cause & Remedy
Recharge battery
(handset only)
The battery needs to be charged. Recharge the
battery (p. 13).
Charge for 6 HRS
(handset only)
The battery has been discharged. The handset will
not work. Charge the battery fully (p. 13).
No link to base.
Walk closer to
base and try
again.
(handset only)
The handset has lost communication with the base
unit. Walk closer to the base unit, and try again.
Plug in the base units AC adaptor.
Raise the base unit antennas.
Please lift up
and try again.
(handset only)
A handset button was pressed while the handset was
on the base unit or the charger. Lift the handset and
press the button again.
Busy
The called unit is in use.
The Privacy mode is on for the call you tried to join
(p. 45).
The unit you tried to send phone book items to is in
use.
The handset you are calling is too far from the base
unit.
Invalid
The called handset has not been registered to the
base unit.
You selected your own extension number.
You pressed [9] instead of entering an extension
number. Enter the extension number (0 to 8) to call.
Error!!
When you tried to register or deregister the handset,
the handset and the base unit could not link for some
reason, such as interference from other electrical
appliances. Move the handset and the base unit
away from electrical appliances and try again.
If more than one handset is in use, you may not be
able to register/deregister. Try again later.
Another unit tried to send phone book items to you
but the transfer has been stopped (p. 38, 39).
Phone book full
When you tried to store an item in the phone book,
the phone book memory is full. Press [OFF] on the
handset or [STOP] on the base unit to exit the
programming mode. To erase other items from the
phone book, see page 37.