Programming
Programmable settings
You can customise the unit by programming the following features using the handset. To access the features, there are 2 methods:
–scrolling through the display menus (page 40)
–using the direct commands (page 44)
LMainly the direct command method is used in these operating instructions. LTo change the base unit ringer volume and tone, see page 26.
Programming by scrolling through the display menus
1
2
3
{MENU} (middle soft key)
Press {^}, {V}, {<}, or {>} to select the desired menu. i{SELECT}
LIf there are
Press {^}, {V}, {<}, or {>} to select (. i{SELECT}
Then press {^} or {V} to select “Ringer volume”. i{SELECT}
Press {^} or {V} to select the desired setting.
LThis step may vary depending on the feature being programmed.
4 {SAVE} i{OFF}
Monochrome display models: KX-TG5961AL/KX-TGA590AL
LWhen you find “*1” or “*2” in the following table, refer to the note below.
*1 If you programme these settings using one of the handsets, you do not need to programme the same item using another handset.
*2 Use either the handset or base unit to turn the dial lock on/off for all units at once (page 28).
Main menu |
| |
Voice Mail | Store VM access#*1 | – |
| Message alert | – |
Page
52
53
40