4Enter an area code (5 digits max.). a
MN a M N
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
RBefore registering the repeater to this base
unit, you must turn the repeater mode on.
RDo not use more than one repeater at a
time.
Setting the repeater mode
1MN
2MbN: “Base Unit Setup” a MN
3MbN: “Repeater Mode” a MN
4MbN: Select the desired setting. a
M N a M N
Note:
RAfter turning the repeater mode on or off,
may flash on the handset momentarily.
This is normal and the handset can be used
once stops flashing.
Registering the DECT repeater
(KX-A405AL) to the base unit
Note:
RPlease use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1Base unit:
Press and hold M N for about 5 seconds,
until the registration tone sounds.
RThe next step must be completed
within 90 seconds.
2DECT repeater:
Connect the AC adaptor, then wait until
the indicator and indicator light
green.
3Base unit:
To exit the registration mode, press MN.
RThe registration tone stops.
21
Programming
TG2721_22AL(en)_0730_ver001.pdf 21TG2721_22AL(en)_0730_ver001.pdf 21 2012/07/30 16:53:052012/07/30 16:53:05